Hi to all. I am currently trying to install SLES10 but have run into a problem with the network setup as follows:
1 for OSA-2 OSA Express 1 for QDIO 1 for Ethernet I then get a list of all my devices I enter the Read channel, Write Channel, Data Channel and Portname I then enter 1 to enable OSI layer 2 support and after entering this I get the following message qeth: Device 0.0.a100/0.0.a101/0.0.a102 is a OSD Express card (level:0845) with link type OSD_1000 (portname:OSAA100) qeth:Error in registering MAC address on device 0.0.a100:x200a Any ideas. SLES8 worked fine on the same OSA card Leon Buitendag Senior Specialist: Systems Programming Data Centre: Numerus Cell: +2783 376 6721 Tel: +2712 336 0628 Fax: +2712 336 0606 E-mail: [EMAIL PROTECTED] This email and any accompanying attachments may contain confidential and proprietary information. This information is private and protected by law and, accordingly, if you are not the intended recipient, you are requested to delete this entire communication immediately and are notified that any disclosure, copying or distribution of or taking any action based on this information is prohibited. Emails cannot be guaranteed to be secure or free of errors or viruses. The sender does not accept any liability or responsibility for any interception, corruption, destruction, loss, late arrival or incompleteness of or tampering or interference with any of the information contained in this email or for its incorrect delivery or non-delivery for whatsoever reason or for its effect on any electronic device of the recipient. ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390
