FYI, RHEL modprobe.conf vs. modules.conf with zipl changed between v3 & v4
Bauer, Bobby (NIH/CIT) [E] wrote:
Very close.
The dasd= parm is in /etc/modprobe.conf, not /etc/zipl.conf.
Brought the dasd online in /sys/bus/ccw/drivers/dasd-eckd and this gave
me the device name to use in the dasdfmt command.
New dasd online and I'm reading about LVM.
Haven't had this much fun since I learned the IBM firewall technologies
a couple of years ago!
Bobby Bauer
Center for Information Technology
National Institutes of Health
Bethesda, MD 20892-5628
301-594-7474
-----Original Message-----
From: Mark Post [mailto:[EMAIL PROTECTED]
Sent: Friday, August 31, 2007 12:34 PM
To: [email protected]
Subject: Re: Adding dasd with Red Hat
On Fri, Aug 31, 2007 at 12:23 PM, in message
<[EMAIL PROTECTED]>, "Bauer,
Bobby
(NIH/CIT) [E]" <[EMAIL PROTECTED]> wrote:
Thanks Mark. I also did find a section in the Red Hat manual on the
topic. I missed it the first time.
So, just for my own info, did it match what I said to do? Or was I off
somewhere?
Mark Post
----------------------------------------------------------------------
For LINUX-390 subscribe / signoff / archive access instructions,
send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or
visit
http://www.marist.edu/htbin/wlvindex?LINUX-390
----------------------------------------------------------------------
For LINUX-390 subscribe / signoff / archive access instructions,
send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit
http://www.marist.edu/htbin/wlvindex?LINUX-390
----------------------------------------------------------------------
For LINUX-390 subscribe / signoff / archive access instructions,
send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit
http://www.marist.edu/htbin/wlvindex?LINUX-390
