Very close. The dasd= parm is in /etc/modprobe.conf, not /etc/zipl.conf.
Brought the dasd online in /sys/bus/ccw/drivers/dasd-eckd and this gave me the device name to use in the dasdfmt command. New dasd online and I'm reading about LVM. Haven't had this much fun since I learned the IBM firewall technologies a couple of years ago! Bobby Bauer Center for Information Technology National Institutes of Health Bethesda, MD 20892-5628 301-594-7474 -----Original Message----- From: Mark Post [mailto:[EMAIL PROTECTED] Sent: Friday, August 31, 2007 12:34 PM To: [email protected] Subject: Re: Adding dasd with Red Hat >>> On Fri, Aug 31, 2007 at 12:23 PM, in message <[EMAIL PROTECTED]>, "Bauer, Bobby (NIH/CIT) [E]" <[EMAIL PROTECTED]> wrote: > Thanks Mark. I also did find a section in the Red Hat manual on the > topic. I missed it the first time. So, just for my own info, did it match what I said to do? Or was I off somewhere? Mark Post ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390 ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390
