Have you confirmed that the NPIV ports are in the same fabric zone as the
clariion ?
Regards,
George Kuch
zSeries zFCP Firmware Development
[EMAIL PROTECTED], 845-435-6806, t/l 295-6806
Jerry Whitteridge
<Jerry.Whitteridg
[EMAIL PROTECTED]> To
Sent by: Linux on [email protected]
390 Port cc
<[EMAIL PROTECTED]
IST.EDU> Subject
Re: zFCP Disk
02/06/2008 02:40
PM
Please respond to
Linux on 390 Port
<[EMAIL PROTECTED]
IST.EDU>
It wasn't intuitive but the steps I took were ( I think) :
1) Gen 2 chpids as FCP with 64 devices each (picked 64 for no good
reason).
2) Activate NPIV on the switch first.
3) Activate NPIV on the chpid.
4) Attach device to VM guest ( q fcp now shows the NPIV WWPN)
5) In linux issued zfcp_host_configure 0.0.xxxx 1 to bring the device
online in linux. This caused the device to log into the switch and the
san folks could see the wwpn.
6) Used YAST to add the device (HARDWARE==>ZFCP) using the target
clarion port wwpn and lun number. (device is unusable at this point)
7) Clarion can now be configured to provision the LUN (zoned ?)
8) Delete the device from YAST
9) Readd the device to YAST
10) Finally was able to format and mount the filesystem.
Jerry Whitteridge
Safeway Inc
925 951 4184
> -----Original Message-----
> From: Linux on 390 Port [mailto:[EMAIL PROTECTED] On
> Behalf Of Craig Collins
> Sent: Wednesday, February 06, 2008 11:17 AM
> To: [email protected]
> Subject: Re: zFCP Disk
>
> We had given up on trying to get the EMC Clariion provisioned
> to SLES10
> using NPIV. The NPIV id for the linux guest is logged into
> the switch and
> is provisioned to EMC DMX3 storage, so we know the connection
> to the switch
> is working. On the Clariion side we can't provision for the NPIV
> connection, as if the NPIV id was not logged into the switch.
>
> So, are you using NPIV with the connections to the EMC
> Clariion and if so,
> do you have any other tips from your experience that might
> help us get this
> to work?
>
"Email Firewall" made the following annotations.
------------------------------------------------------------------------------
Warning:
All e-mail sent to this address will be received by the corporate e-mail
system, and is subject to archival and review by someone other than the
recipient. This e-mail may contain proprietary information and is intended
only for the use of the intended recipient(s). If the reader of this
message is not the intended recipient(s), you are notified that you have
received this message in error and that any review, dissemination,
distribution or copying of this message is strictly prohibited. If you
have received this message in error, please notify the sender immediately.
==============================================================================
----------------------------------------------------------------------
For LINUX-390 subscribe / signoff / archive access instructions,
send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or
visit
http://www.marist.edu/htbin/wlvindex?LINUX-390
----------------------------------------------------------------------
For LINUX-390 subscribe / signoff / archive access instructions,
send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit
http://www.marist.edu/htbin/wlvindex?LINUX-390
