YaST is very good at doing this, but if you must use the command line I always check the how to. I think it's on the RedHat web site. A Google search should find it.
Tom Duerbusch wrote:
Somewhere, there was a document, that was part of a manual that explained the steps needed in adding another disk to a LVM pool. I can't find it. So, I tried to do it from memory and yast seemed fine with it. But when I added the disk to the pool, and then selected "max" to add the entire disk in, it didn't. I think I took the defaults when setting up LVM. There is one way of setting up LVM, that has better performance at the expense of not being able to expand it. I don't think I set it up that way. Anyway, I would like to find that manual again. Thanks SLES 10 SP2 Tom Duerbusch THD Consulting ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390
-- Rich Smrcina VM Assist, Inc. Phone: 414-491-6001 Ans Service: 360-715-2467 http://www.linkedin.com/in/richsmrcina Catch the WAVV! http://www.wavv.org WAVV 2009 - Orlando, FL - May 15-19, 2009 ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390
