Robin, OK I see what your problem is now:
CTCA 0E22 ATTACHED TO DTCVSW2 0E22
CTCA 0E23 ATTACHED TO DTCVSW2 0E23
These devices need to be attached to the TCPIP virtual machine, and not to the
default
VSWITCH controller virtual machine.
DJ
Robin Atwood wrote:
I am playing around with z/VM V5R3 Eval Edition which now IPLs under Hercules
3.06. It's intended to demonstrate running Linux under z/VM but before I can
do that I have to get the networking for VM going. I have altered PROFILE
TCPIP to use a CTC but when I logon TCPIP I get messages:
DTCCTC080I CTCA initializing:
DTCPRI385I Device CTCA0:
DTCPRI386I Type: CTC, Status: Not started
and CTCA shuts down. The CTCs are defined and attached OK:
q ctca
CTCA 0E22 ATTACHED TO DTCVSW2 0E22
CTCA 0E23 ATTACHED TO DTCVSW2 0E23
This almost certainly something totally obvious but I am a VM n00b; what have
I missed out?
TIA
-Robin
--
----------------------------------------------------------------------
Robin Atwood.
"Ship me somewheres east of Suez, where the best is like the worst,
Where there ain't no Ten Commandments an' a man can raise a thirst"
from "Mandalay" by Rudyard Kipling
----------------------------------------------------------------------
----------------------------------------------------------------------
For LINUX-390 subscribe / signoff / archive access instructions,
send email to [email protected] with the message: INFO LINUX-390 or visit
http://www.marist.edu/htbin/wlvindex?LINUX-390
--
DJ
V/Soft
z/VM and mainframe Linux expertise, training,
consulting, and software development
www.vsoft-software.com
----------------------------------------------------------------------
For LINUX-390 subscribe / signoff / archive access instructions,
send email to [email protected] with the message: INFO LINUX-390 or visit
http://www.marist.edu/htbin/wlvindex?LINUX-390
