For comparison have a look at cp q nic details and note the difference between Adapter MAC and Unicast MAC.... Anyway, I have set up a production test for tonight that will transfer on the order of 2-3 TB with about 100 clients. We'll see what will happen there both balance and performance wise.
Best regards, Pieter Harder [email protected] tel +31-73-6837133 / +31-6-47272537 -----Oorspronkelijk bericht----- Van: Linux on 390 Port [mailto:[email protected]] Namens Marcy Cortes Verzonden: vrijdag 23 januari 2009 16:59 Aan: [email protected] Onderwerp: Re: bonding multiple qeth vnics to vswitch? Right, And not sure if it would help Pieter's problem anyway: # ifconfig bond0 Link encap:Ethernet HWaddr 02:00:00:00:00:41 inet addr:10.93.27.250 Bcast:10.93.27.255 Mask:255.255.255.0 inet6 addr: fe80::ff:fe00:41/64 Scope:Link UP BROADCAST RUNNING MASTER MULTICAST MTU:1500 Metric:1 RX packets:412326 errors:0 dropped:0 overruns:0 frame:0 TX packets:513783 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:115082811 (109.7 Mb) TX bytes:127188062 (121.2 Mb) eth0 Link encap:Ethernet HWaddr 02:00:00:00:00:41 UP BROADCAST RUNNING SLAVE MULTICAST MTU:1500 Metric:1 RX packets:394205 errors:0 dropped:0 overruns:0 frame:0 TX packets:513781 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:114199553 (108.9 Mb) TX bytes:127187894 (121.2 Mb) eth1 Link encap:Ethernet HWaddr 02:00:00:00:00:41 UP BROADCAST RUNNING SLAVE MULTICAST MTU:1500 Metric:1 RX packets:18121 errors:0 dropped:0 overruns:0 frame:0 TX packets:2 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:883258 (862.5 Kb) TX bytes:168 (168.0 b) lo Link encap:Local Loopback inet addr:127.0.0.1 Mask:255.0.0.0 inet6 addr: ::1/128 Scope:Host UP LOOPBACK RUNNING MTU:16436 Metric:1 RX packets:198 errors:0 dropped:0 overruns:0 frame:0 TX packets:198 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:11715 (11.4 Kb) TX bytes:11715 (11.4 Kb) Given the counts, it seems to greatly favor one over the other (this one is sles 10 sp2) Marcy "This message may contain confidential and/or privileged information. If you are not the addressee or authorized to receive this for the addressee, you must not use, copy, disclose, or take any action based on this message or any information herein. If you have received this message in error, please advise the sender immediately by reply e-mail and delete this message. Thank you for your cooperation." -----Original Message----- From: Linux on 390 Port [mailto:[email protected]] On Behalf Of Mark Post Sent: Friday, January 23, 2009 7:53 AM To: [email protected] Subject: Re: [LINUX-390] bonding multiple qeth vnics to vswitch? >>> On 1/22/2009 at 6:51 PM, Alan Altmark <[email protected]> wrote: -snip- > While you can have multiple vNICs on an aggregating VSWITCH, there's > nothing that will spray/deal queued frames across the vNICs since they > each have a unique MAC address. When the bonded NIC starts up, both of the slave's MAC addresses are set to be the same. So, they're not unique. Mark Post ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390 ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390 Brabant Water N.V. Postbus 1068 5200 BC 's-Hertogenbosch http://www.brabantwater.nl Handelsregister: 16005077 ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390
