> Would the Q V NIC DET show any different results than the Q VSWITCH DET
> on VM? When I take a look at another guest the output from both commands
> is almost the same.
One of the things that show up on the q v nic det that does not appear to
show up on the q vswitch det is the actual MAC given by the vswitch to the
nic, ex:
CP Q V NIC 1600 DETAIL
Adapter 1600.P00 Type: QDIO Name: UNASSIGNED Devices: 3
MAC: 02-06-00-00-00-52 VSWITCH: SYSTEM DT70L2 <-- MAC from
vswitch
RX Packets: 2562 Discarded: 0 Errors: 0
TX Packets: 576 Discarded: 0 Errors: 0
RX Bytes: 186892 TX Bytes: 78429
Connection Name: HALLOLE State: Session Established
Device: 1600 Unit: 000 Role: CTL-READ
Device: 1601 Unit: 001 Role: CTL-WRITE
Device: 1602 Unit: 002 Role: DATA vPort: 0078 Index: 0008
Options: Ethernet Broadcast
Unicast MAC Addresses:
02-06-FF-FF-FF-01 <-- MAC set by user for the nic
I'm not sure if it would make a difference with Layer3 mode. On SLES-11
you can't set the MAC on the nic if it's in layer3, but maybe it was
possible on SLES-8.
- Mark Ver
office: Building 710 / Room 2-RF-10
phone: (845) 435-7794 [tie 8 295-7794]
----------------------------------------------------------------------
For LINUX-390 subscribe / signoff / archive access instructions,
send email to [email protected] with the message: INFO LINUX-390 or visit
http://www.marist.edu/htbin/wlvindex?LINUX-390
