On Thu, 2012-11-01 at 09:57 +0000, van Sleeuwen, Berry wrote: > I tried to activate with these commands, as well as with znetconf but that > was still not successful. After installing the most recent patches, the > kernel is now on 2.6.32.59, the ccwgroup device 0.0.efac is activated during > boot. Since it's now active we can test the new CCL once again. > > The funny thing is we are upgrading, from SLES9 to SLES11, just to have a > supported version before we migrate to a new CPU. But indeed, the installed > SLES11 level was not the most recent. > > Since it's an OSN it must be layer2. Even more so, files portname, portno and > layer2 are not available in /sys/bus/ccwgroup/drivers/qeth/0.0.efac/. But it > looks like that's the same in SLES9. During boot there is no comment about > that on SLES9, on SLES11 udev complains about these rules. >
Berry, now I recognize my first hint has been useless for you - sorry. Your problem is specific to OSN. OSN-devices are special OSA-devices which offer just a few writable sysfs-attributes (buffer_count and recover). Thus it does not make sense to have definitions for portname, portno, and layer2 in a udev-rule for an OSN-device. I assume your udev-rule has been created by yast - correct? Regards, Ursula Braun, IBM Germany ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390 ---------------------------------------------------------------------- For more information on Linux on System z, visit http://wiki.linuxvm.org/
