On Wed Oct 13 1999 at 19:06, [EMAIL PROTECTED] wrote:
> You can access to local management port, using a serial connection. The
> software is a terminal emulator (e.g. HyperTerminal, dip, etc.).
To make this a little clearer...
Get a local serial connection and a console into the cisco, eg using
minicom on a linux box.
Power cycle the cisco box.
When it's booting up, send a Break signal to it, then you'll get a
configuration menu from where you'll be able to reset all the
passwords.
This might depend on the exact model of the cisco box you have there,
but it works on ours.
> Regards,
>
> RMj.
>
> On Wed, 13 Oct 1999, Nasir Ahmed wrote:
>
> > I have a WAN using Linux Servers and Cisco Routers.
> >
> > In one of the routers I have lost the password and I need to reconfigure
> > the router urgently.
> >
> > Any way by which I can reset / recover the router password ?
> >
> > Prompt response will be appreciated
> >
> > Regards,
> >
> > Nasir
> >
>
Cheers
Tony
-=*#*=-=*#*=-=*#*=-=*#*=-=*#*=-=*#*=-=*#*=-=*#*=-=*#*=-=*#*=-=*#*=-
Tony Nugent <[EMAIL PROTECTED]> Systems Administrator
GrowZone OnLine (a project of) GrowZone Development Network
POBox 475 Toowoomba Oueensland Australia 4350 Ph: 07 4632 8344
-=*#*=-=*#*=-=*#*=-=*#*=-=*#*=-=*#*=-=*#*=-=*#*=-=*#*=-=*#*=-=*#*=-
