Hi Hans, with this configuration it does not work. As I commented it seems
that it does not work if GPIO6 is set to 1. If I change to 0 it works fine.
Just one comment, GPIO0 for sure is the LED output of my card. :P
Albert
2008/2/17, Hans-Frieder Vogt <[EMAIL PROTECTED]>:
>
> Albert,
>
> I am happy to hear that your TV-card finally works.
> However, I am still a bit unsure about these GPIO settings. Initially, I
> just copied the GPIO-settings from another entry and
> then left it because it seemed to work. Now, I have digged a little bit
> into this issue and found, that under Windows my
> STK7700PH-based stick gets the GPIO set in a different way.
> Could you please try the following modified stk7700ph_frontend_attach
> routine (in dib0700_devices.c) and tell me
> whether this works for your card as well?
>
>
> static int stk7700ph_frontend_attach(struct dvb_usb_adapter *adap)
>
> {
>
> dib0700_set_gpio(adap->dev, GPIO6, GPIO_OUT, 1);
>
> msleep(20);
>
> dib0700_set_gpio(adap->dev, GPIO9, GPIO_OUT, 1);
>
> dib0700_set_gpio(adap->dev, GPIO4, GPIO_OUT, 1);
> dib0700_set_gpio(adap->dev, GPIO7, GPIO_OUT, 1);
>
> dib0700_set_gpio(adap->dev, GPIO10, GPIO_OUT, 0);
> msleep(10);
>
> dib0700_set_gpio(adap->dev, GPIO10, GPIO_OUT, 1);
>
> msleep(20);
>
> dib0700_set_gpio(adap->dev, GPIO0, GPIO_OUT, 1);
>
> msleep(10);
>
>
> dib7000p_i2c_enumeration(&adap->dev->i2c_adap, 1, 18,
> &stk7700ph_dib7700_xc3028_config);
>
> adap->fe = dvb_attach(dib7000p_attach, &adap->dev->i2c_adap, 0x80,
> &stk7700ph_dib7700_xc3028_config);
>
> return adap->fe == NULL ? -ENODEV : 0;
> }
>
>
> By the way, I also experience the same problem with the missing SNR info,
> on two different dib0700-based USB cards.
>
> Regards,
> Hans-Frieder
>
> Am Sonntag, 17. Februar 2008 schrieb Albert Comerma:
>
> > I got it!!!! I remembered that on PCTV DVB-T 72e they had a similar
> problem,
> > which was solved leaving GPIO6 to 0. Doing this the tuning seems to work
> > fine. SNR is always reported as 0% but I think this is not a problem,
> now I
> > can scan and tune dvb-t channels. Firmware is 1.10 and xc3028-v27 with
> that
> > modification. Thanks a lot for your help. Next step would be analog.
> >
> > Albert
> >
>
>
>
>
> --
>
> --
> Hans-Frieder Vogt e-mail: hfvogt <at> gmx .dot. net
>
_______________________________________________
linux-dvb mailing list
linux-dvb@linuxtv.org
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
