Hi, Your mail is very vertical, so to speak, and quite hard to find the relevant info in it.
As far as I understood, you seem to have the virtual IP on both nodes, right? That should never happen under normal circumstances. Do you see anything in the logs? Can you try stopping the heartbeat on both nodes then making sure that the virtual IP is no present on either node, and finally starting the heartbeats? If the same thing happens, then something is very wrong with your setup/software. Again, there should be clues in the logs. No, the thing should have nothing to do with your other resource (rsynclient) taking some time to run. Cheers, Dejan On Fri, Aug 25, 2006 at 12:00:29AM +0530, nishant kumar wrote: > Hi, > In my two-node cluster the ip specified in haresources > is getting masqueraded in both machines. > > Configuration files are as follows:- > --------------------------------------------- > 1.haresources: > > master 192.168.184.69 rsyncserver > slave_mac rsynclient > > 2.ha.cf > > logfile /var/log/ha-log > keepalive 2 > deadtime 10 > warntime 4 > initdead 30 > node master > node slave_mac > bcast neoeth0 > udpport 694 > auto_failback on > coredumps true > debug 0 > realtime on > use_logd off > > > > As shown below the , IP written in haresources is on > both machine > ----------------------------------------- > [EMAIL PROTECTED] 2008]# uname -n > master > [EMAIL PROTECTED] 2008]# ifconfig > eth0 Link encap:Ethernet HWaddr > 00:0C:29:8D:3F:C2 > UP BROADCAST RUNNING PROMISC MULTICAST > MTU:1500 Metric:1 > RX packets:3317 errors:0 dropped:0 > overruns:0 frame:0 > TX packets:1661 errors:0 dropped:0 > overruns:0 carrier:0 > collisions:0 txqueuelen:1000 > RX bytes:380532 (371.6 Kb) TX bytes:333306 > (325.4 Kb) > Interrupt:10 Base address:0x1400 > > eth1 Link encap:Ethernet HWaddr > 00:0C:29:8D:3F:CC > inet addr:192.168.11.129 > Bcast:192.168.11.255 Mask:255.255.255.0 > UP BROADCAST RUNNING MULTICAST MTU:1500 > Metric:1 > RX packets:909 errors:0 dropped:0 overruns:0 > frame:0 > TX packets:14 errors:0 dropped:0 overruns:0 > carrier:0 > collisions:0 txqueuelen:1000 > RX bytes:208698 (203.8 Kb) TX bytes:588 > (588.0 b) > Interrupt:9 Base address:0x1480 > lo Link encap:Local Loopback > inet addr:127.0.0.1 Mask:255.0.0.0 > UP LOOPBACK RUNNING MTU:16436 Metric:1 > RX packets:16 errors:0 dropped:0 overruns:0 > frame:0 > TX packets:16 errors:0 dropped:0 overruns:0 > carrier:0 > collisions:0 txqueuelen:0 > RX bytes:1000 (1000.0 b) TX bytes:1000 > (1000.0 b) > > > neoeth0 Link encap:Ethernet HWaddr > 00:0C:29:8D:3F:C2 > inet addr:192.168.184.129 > Bcast:192.168.184.255 Mask:255.255.255.0 > UP BROADCAST RUNNING MULTICAST MTU:1500 > Metric:1 > RX packets:2847 errors:0 dropped:0 > overruns:0 frame:0 > TX packets:1668 errors:0 dropped:0 > overruns:0 carrier:0 > collisions:0 txqueuelen:0 > RX bytes:293663 (286.7 Kb) TX bytes:336180 > (328.3 Kb) > > neoeth0:0 Link encap:Ethernet HWaddr > 00:0C:29:8D:3F:C2 > inet addr:192.168.184.69 > Bcast:192.168.184.255 Mask:255.255.255.0 > UP BROADCAST RUNNING MULTICAST MTU:1500 > Metric:1 > > > [EMAIL PROTECTED] root]# uname -n > slave_mac > [EMAIL PROTECTED] root]# ifconfig > eth0 Link encap:Ethernet HWaddr > 00:0C:29:F2:01:F3 > UP BROADCAST RUNNING PROMISC MULTICAST > MTU:1500 Metric:1 > RX packets:118285 errors:0 dropped:0 > overruns:0 frame:0 > TX packets:85694 errors:0 dropped:0 > overruns:0 carrier:0 > collisions:0 txqueuelen:1000 > RX bytes:28751827 (27.4 Mb) TX > bytes:8001939 (7.6 Mb) > Interrupt:10 Base address:0x1400 > > eth1 Link encap:Ethernet HWaddr > 00:0C:29:F2:01:FD > inet addr:192.168.11.130 > Bcast:192.168.11.255 Mask:255.255.255.0 > UP BROADCAST RUNNING MULTICAST MTU:1500 > Metric:1 > RX packets:36083 errors:0 dropped:0 > overruns:0 frame:0 > TX packets:2772 errors:0 dropped:0 > overruns:0 carrier:0 > collisions:0 txqueuelen:1000 > RX bytes:24052810 (22.9 Mb) TX bytes:223247 > (218.0 Kb) > Interrupt:9 Base address:0x1480 > > lo Link encap:Local Loopback > inet addr:127.0.0.1 Mask:255.0.0.0 > UP LOOPBACK RUNNING MTU:16436 Metric:1 > RX packets:36 errors:0 dropped:0 overruns:0 > frame:0 > TX packets:36 errors:0 dropped:0 overruns:0 > carrier:0 > collisions:0 txqueuelen:0 > RX bytes:3614 (3.5 Kb) TX bytes:3614 (3.5 > Kb) > > neoeth0 Link encap:Ethernet HWaddr > 00:0C:29:F2:01:F3 > inet addr:192.168.184.130 > Bcast:192.168.184.255 Mask:255.255.255.0 > UP BROADCAST RUNNING MULTICAST MTU:1500 > Metric:1 > RX packets:77279 errors:0 dropped:0 > overruns:0 frame:0 > TX packets:85692 errors:0 dropped:0 > overruns:0 carrier:0 > collisions:0 txqueuelen:0 > RX bytes:4989385 (4.7 Mb) TX bytes:8002641 > (7.6 Mb) > > neoeth0:0 Link encap:Ethernet HWaddr > 00:0C:29:F2:01:F3 > inet addr:192.168.184.69 > Bcast:192.168.184.255 Mask:255.255.255.0 > UP BROADCAST RUNNING MULTICAST MTU:1500 > Metric:1 > > > > I am most probably using 1.31 as shown by this > ResourceManager script > ($Id: ResourceManager.in,v 1.31 2005/08/31 16:03:02 > alan Exp $) > I am not using crm. I am using very basic setup of > heartbeat with SPOF ;both nodes are on the same > ethernet LAN. > > NOTE: My rsynclient resource script takes a while to > complete, is that a problem? > Also timings in various timers is too short in here ? > or it will work smoothly ?? > > Thanks for your patience > Nish > _______________________________________________ > Linux-HA mailing list > [EMAIL PROTECTED] > http://lists.linux-ha.org/mailman/listinfo/linux-ha > See also: http://linux-ha.org/ReportingProblems _______________________________________________________ Linux-HA-Dev: [email protected] http://lists.linux-ha.org/mailman/listinfo/linux-ha-dev Home Page: http://linux-ha.org/
