The way I set it up was to start minicom, hit "ctrl-A" then 'o' to get
to the setup screen. Then I told it what serial ports to use and
databits parity etc. If it's not "detecting" a serial port, you might
not have a /dev/ttyS1(should be com2 I think). If you don't have that,
make sure you had serial support checked last time you compiled your
kernel.
The ax-25 howto is great, but I'm having problems completing some of the
instructions...
no problem with the howto, but my system.
I'm running 2.1.131 with most of the options checked.
I downloaded and untarred the ax25-utils-2.1.42.
And did make to configure, included all the options.
Then did make again. The error file is below
make[1]: Entering directory `/usr/src/ax25-utils-2.1.42/lib'
gcc -Wall -Wstrict-prototypes -O2 -c -o axutils.o axutils.c
gcc -Wall -Wstrict-prototypes -O2 -c -o axconfig.o axconfig.c
gcc -Wall -Wstrict-prototypes -O2 -c -o daemon.o daemon.c
gcc -Wall -Wstrict-prototypes -O2 -c -o nrconfig.o nrconfig.c
gcc -Wall -Wstrict-prototypes -O2 -c -o procutils.o procutils.c
procutils.c: In function `read_proc_ax25':
procutils.c:36: `errno' undeclared (first use this function)
procutils.c:36: (Each undeclared identifier is reported only once
procutils.c:36: for each function it appears in.)
procutils.c: In function `read_proc_ax25_route':
procutils.c:107: `errno' undeclared (first use this function)
procutils.c: In function `read_proc_nr_neigh':
procutils.c:154: `errno' undeclared (first use this function)
procutils.c: In function `read_proc_nr_nodes':
procutils.c:194: `errno' undeclared (first use this function)
procutils.c: In function `get_call':
procutils.c:255: `errno' undeclared (first use this function)
make[1]: *** [procutils.o] Error 1
make[1]: Leaving directory `/usr/src/ax25-utils-2.1.42/lib'
make: *** [all] Error 2
-Ron, KB0NUV
