I haven't tried it myself, but I understand that ax25-utils-2.1.42a is not
compatible with the later 2.1.x kernels (as I recall, there were changes
around 2.1.100 or so). This won't affect using a TNC with minicom, of
course.
Bob
On Thu, 10 Dec 1998, Ron Alford wrote:
> The way I set it up was to start minicom, hit "ctrl-A" then 'o' to get
> to the setup screen. Then I told it what serial ports to use and
> databits parity etc. If it's not "detecting" a serial port, you might
> not have a /dev/ttyS1(should be com2 I think). If you don't have that,
> make sure you had serial support checked last time you compiled your
> kernel.
>
> The ax-25 howto is great, but I'm having problems completing some of the
> instructions...
> no problem with the howto, but my system.
> I'm running 2.1.131 with most of the options checked.
> I downloaded and untarred the ax25-utils-2.1.42.
> And did make to configure, included all the options.
> Then did make again. The error file is attached.
>
>
----
Bob Nielsen Internet: [EMAIL PROTECTED]
Tucson, AZ AMPRnet: [EMAIL PROTECTED]
DM42nh http://www.primenet.com/~nielsen
