Erik Jakobsen wrote :
> Hi.
>
> Today I wired up the wires between my rotor G1000SDX. I run the kctcal,
> but found that the wanted value 255 could not be reached. Just a value
> of 212 was the maximum. You se the rotor I have has an overlap of 90
> degrees. I I turned the rotor these 405 degrees the 255 as well as the
> controlvoltage was ok now. 255 and 5 V's.
>
> Well I looked for the rotor command and could not find it.
>
> The I found the kctpos azimut <degrees>, and it worked.
>
> I would be glad if somebody can help me how to get the value 255 ok on
> a 360 degrees turn.
>
> The next is my forward.sys and included scripts. Can I use:
>
> x kctpos azimut 45
> xc kctpos azimut 45
>
> Tnx for any reply.
>
> 73, Erik OZ4KK.
>
> --
> **************************************
> * *
> * Best regards - de bedste hilsener. *
> * *
> * Erik Jakobsen - [EMAIL PROTECTED] *
> * *
> **************************************
In my experience using KCT/T system with the driver writen by F6FBB kctpos
needs Az as well as El values
on the command line i.e. for example
kctpos 140 10
It cannot work without modification with AZ only.
Also it will wait until it receives the information from both rotors that the
Az and El values are correct.
Thus, if you have both rotors but do not switch on your elevation rotor, the
program will wait for a long long time....
73 de Bernard, f6bvp
