Erik Jakobsen a �crit :
>
> Hi.
>
> Today I wired up the wires between my rotor G1000SDX. I run the kctcal,
> but found that the wanted value 255 could not be reached. Just a value
> of 212 was the maximum. You se the rotor I have has an overlap of 90
> degrees. I I turned the rotor these 405 degrees the 255 as well as the
> controlvoltage was ok now. 255 and 5 V's.
>
> Well I looked for the rotor command and could not find it.
>
> The I found the kctpos azimut <degrees>, and it worked.
>
> I would be glad if somebody can help me how to get the value 255 ok on
> a 360 degrees turn.
>
> The next is my forward.sys and included scripts. Can I use:
>
> x kctpos azimut 45
> xc kctpos azimut 45
>
> Tnx for any reply.
>
> 73, Erik OZ4KK.
>
You need to modify the kct.conf file accordingly.
Here is my own configuration file that I found working correctly.
My Az rotor is a 360 degree with the stop position toward SOUTH.
KCTCAL indicates 0 when it is pointing South conterclockwise (180 degrees),
127 when the antenna is aiming North (0 degrees) and 255 when the antenna is
aiming South but fully clockwise (180 degrees).
[CALIBRATION]
AZIMUTH_ORIGIN = 180
AZIMUTH_MIN = 0
AZIMUTH_MAX = 255
ELEVATION_ORIGIN = 0
ELEVATION_MIN = 3
ELEVATION_MAX= 255
> --
> **************************************
> * *
> * Best regards - de bedste hilsener. *
> * *
> * Erik Jakobsen - [EMAIL PROTECTED] *
> * *
> **************************************
>
> _______________________________________________
> xfbb maillist - [EMAIL PROTECTED]
> http://www.f6fbb.org/mailman/listinfo/xfbb
73 de Bernard, f6bvp
