On Thu, 10 Aug 2000, Steve Stuart wrote:
> I've just installed the ax-25 stuff,
> node-0.3.0-1.i386.rpm,
> libax25-0.0.7-1.i386.rpm
> ax25-tools-0.0.5-1.i386.rpm
> ax25-apps-0.0.4-1.i386.rpm
> on RedHat 6.2 system (2.2.14-5.0) with a pentium 133 and 80M
> ram. Recompiled/installed the kernal (and modules) with ham
> radio stuff enabled. Then set up /etc/ax25/axports with the
> line: "ax0 W8AN-4 9600 255 2 144.050 MHz (9600 baud)". Modprobe
Wild guess: your TNC serial line bit rate is not 9600 but something else?
That 9600 at the speed field of axports is used for the serial bit rate,
not the radio bit rate.
> mkiss successful.
> Next "kissattach /dev/ttyS0 ax0 44.70.161.132" followed by
> "/etc/rc.d/init.d/ax25d start". Even setup a couple routes to
Just to be on the safe side: Ax25d is not needed for outgoing connections
or tcp/ip over ax25. And if you do want incoming connections, you did edit
/etc/ax25/ax25d.conf right? Otherwise you'll be using my callsign... :)
--
Tomi Manninen Internet: [EMAIL PROTECTED]
OH2BNS AX.25: [EMAIL PROTECTED]
KP20ME04 Amprnet: [EMAIL PROTECTED]
