Am Sa, 26.01.2008, 23:33, schrieb Tejun Heo:
>> I could solve the problem by ncq blacklisting the "Maxtor 6V300F0"
>> devices in libata-core.c
> That's a strange story.  The reported error was PHY readiness changed
> and Device exchanged, both of which point to hotplug event.  Maybe
> something causes the firmware to reset?  What happen if you only leave two
> drives on the port multiplier and remove the NCQ blacklist?  Also, does
> the error ever occur on the drives which are connected directly to the
> controller?
> --
> tejun

No the error only occures on the drives on the pm. I can test the pm with
two Maxtor drives tomorrow (currently backing up the raid).

To unsubscribe from this list: send the line "unsubscribe linux-ide" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at

Reply via email to