On 10/11/2018 08:34 PM, Dan Murphy wrote:
> Pavel
>
> On 10/11/2018 01:27 PM, Pavel Machek wrote:
>> On Thu 2018-10-11 11:51:16, Dan Murphy wrote:
>>> Remove support for the LM3697 LED device
>>> from the ti-lmu. The LM3697 will be supported
>>> via a stand alone LED driver.
>>>
>>> Signed-off-by: Dan Murphy <[email protected]>
>>
>> NAK.
>
> Thanks for the NAK.
>
> This NAK was NAK'd by other maintainer in the V2 RFC patchset
>
> https://lore.kernel.org/patchwork/patch/993171/
I confirm. LM3697 is a standalone device and not a cell of any
MFD device.
Waiting for DT maintainer's ack.
Best regards,
Jacek Anaszewski
>>> index c885cf89b8ce..920f910be4e9 100644
>>> --- a/Documentation/devicetree/bindings/mfd/ti-lmu.txt
>>> +++ b/Documentation/devicetree/bindings/mfd/ti-lmu.txt
>>> @@ -9,7 +9,6 @@ TI LMU driver supports lighting devices below.
>>> LM3632 Backlight and regulator
>>> LM3633 Backlight, LED and fault monitor
>>> LM3695 Backlight
>>> - LM3697 Backlight and fault monitor
>>>
>>> Required properties:
>>> - compatible: Should be one of:
>>> @@ -18,11 +17,10 @@ Required properties:
>>> "ti,lm3632"
>>> "ti,lm3633"
>>> "ti,lm3695"
>>> - "ti,lm3697"
>>> - reg: I2C slave address.
>>> 0x11 for LM3632
>>> 0x29 for LM3631
>>> - 0x36 for LM3633, LM3697
>>> + 0x36 for LM3633
>>> 0x38 for LM3532
>>> 0x63 for LM3695
>>>
>>> @@ -38,7 +36,6 @@ Optional nodes:
>>> Required properties:
>>> - compatible: Should be one of:
>>> "ti,lm3633-fault-monitor"
>>> - "ti,lm3697-fault-monitor"
>>> - leds: LED properties for LM3633. Please refer to [2].
>>> - regulators: Regulator properties for LM3631 and LM3632.
>>> Please refer to [3].
>>> @@ -220,24 +217,3 @@ lm3695@63 {
>>> };
>>> };
>>> };
>>> -
>>> -lm3697@36 {
>>> - compatible = "ti,lm3697";
>>> - reg = <0x36>;
>>> -
>>> - enable-gpios = <&pioC 2 GPIO_ACTIVE_HIGH>;
>>> -
>>> - backlight {
>>> - compatible = "ti,lm3697-backlight";
>>> -
>>> - lcd {
>>> - led-sources = <0 1 2>;
>>> - ramp-up-msec = <200>;
>>> - ramp-down-msec = <200>;
>>> - };
>>> - };
>>> -
>>> - fault-monitor {
>>> - compatible = "ti,lm3697-fault-monitor";
>>> - };
>>> -};
>>
>
>
