Remove support for the LM3633 LED device from the ti-lmu. The LM3633 will be supported via a stand alone LED driver.
Signed-off-by: Dan Murphy <[email protected]> --- .../devicetree/bindings/mfd/ti-lmu.txt | 48 ------------------- 1 file changed, 48 deletions(-) diff --git a/Documentation/devicetree/bindings/mfd/ti-lmu.txt b/Documentation/devicetree/bindings/mfd/ti-lmu.txt index 920f910be4e9..573e88578d3d 100644 --- a/Documentation/devicetree/bindings/mfd/ti-lmu.txt +++ b/Documentation/devicetree/bindings/mfd/ti-lmu.txt @@ -7,7 +7,6 @@ TI LMU driver supports lighting devices below. LM3532 Backlight LM3631 Backlight and regulator LM3632 Backlight and regulator - LM3633 Backlight, LED and fault monitor LM3695 Backlight Required properties: @@ -15,12 +14,10 @@ Required properties: "ti,lm3532" "ti,lm3631" "ti,lm3632" - "ti,lm3633" "ti,lm3695" - reg: I2C slave address. 0x11 for LM3632 0x29 for LM3631 - 0x36 for LM3633 0x38 for LM3532 0x63 for LM3695 @@ -157,51 +154,6 @@ lm3632@11 { }; }; -lm3633@36 { - compatible = "ti,lm3633"; - reg = <0x36>; - - enable-gpios = <&pioC 2 GPIO_ACTIVE_HIGH>; - - backlight { - compatible = "ti,lm3633-backlight"; - - main { - label = "main_lcd"; - led-sources = <1 2>; - ramp-up-msec = <500>; - ramp-down-msec = <500>; - }; - - front { - label = "front_lcd"; - led-sources = <0>; - ramp-up-msec = <1000>; - ramp-down-msec = <0>; - }; - }; - - leds { - compatible = "ti,lm3633-leds"; - - chan1 { - label = "status"; - led-sources = <1>; - led-max-microamp = <6000>; - }; - - chan345 { - label = "rgb"; - led-sources = <3 4 5>; - led-max-microamp = <10000>; - }; - }; - - fault-monitor { - compatible = "ti,lm3633-fault-monitor"; - }; -}; - lm3695@63 { compatible = "ti,lm3695"; reg = <0x63>; -- 2.19.0
