[PATCH 4/4] phy: qualcomm: phy-qcom-eusb2-repeater: Add support for PMIV0104

[Luca Weiss]

Add support for the eUSB2 repeater found on the PMIV0104. There is no
default init table for this PMIC, just the board-specific tuning
parameters are used on top of the default tuning values.

Signed-off-by: Luca Weiss <luca.we...@fairphone.com>
---
 drivers/phy/qualcomm/phy-qcom-eusb2-repeater.c | 12 ++++++++++++
 1 file changed, 12 insertions(+)

diff --git a/drivers/phy/qualcomm/phy-qcom-eusb2-repeater.c 
b/drivers/phy/qualcomm/phy-qcom-eusb2-repeater.c
index 
61594739e5b12706775622e1f76af6ad5d2d29bf..3d4cdc4c18becd8efd5015e698b836ad4d7cf18c
 100644
--- a/drivers/phy/qualcomm/phy-qcom-eusb2-repeater.c
+++ b/drivers/phy/qualcomm/phy-qcom-eusb2-repeater.c
@@ -82,6 +82,14 @@ static const struct eusb2_repeater_cfg pm8550b_eusb2_cfg = {
        .num_vregs      = ARRAY_SIZE(pm8550b_vreg_l),
 };
 
+static const struct eusb2_repeater_cfg pmiv0104_eusb2_cfg = {
+       /* No PMIC-specific init sequence, only board level tuning via DT */
+       .init_tbl       = (struct eusb2_repeater_init_tbl_reg[]) {},
+       .init_tbl_num   = 0,
+       .vreg_list      = pm8550b_vreg_l,
+       .num_vregs      = ARRAY_SIZE(pm8550b_vreg_l),
+};
+
 static const struct eusb2_repeater_cfg smb2360_eusb2_cfg = {
        .init_tbl       = smb2360_init_tbl,
        .init_tbl_num   = ARRAY_SIZE(smb2360_init_tbl),
@@ -264,6 +272,10 @@ static const struct of_device_id 
eusb2_repeater_of_match_table[] = {
                .compatible = "qcom,pm8550b-eusb2-repeater",
                .data = &pm8550b_eusb2_cfg,
        },
+       {
+               .compatible = "qcom,pmiv0104-eusb2-repeater",
+               .data = &pmiv0104_eusb2_cfg,
+       },
        {
                .compatible = "qcom,smb2360-eusb2-repeater",
                .data = &smb2360_eusb2_cfg,

-- 
2.50.0