On Sat, 14 Apr 2001, kero chan wrote:
> Hi,
>
> I recently re-installed RHLinux7 onto my P166 box.
> Before doing that, my NIC card, LINKSYS EtherFast
> 10/100, was probed and working fine, but now, it
> cannot be found. When I type 'ifconfig -a', it shows
> only loopback (lo). Through 'linuxconf', I set
> following parameters:
>
> ...
> nnet device: eth0
> kernel module: tulip
Are you "sure" that is the correct driver.?????
> ...
>
> (BTW, how do I find which I/O port and Irq the card
> should be or are using?)
If it is a PCI card (one would imagen it is) then cat /proc/net/pci will tell
you.
>
> Then after rebooting, I see "...network: Bringing up
> interface eth0: failed" in the /var/log/boot.log file.
> What else must I do to install my NIC?
I suggest you read the Ethernet-HOWTO wich i am sure you have in your
/usr/doc/* dir, read section 5.24. LinkSys
>
> TIA,
> kero
>
--
Regards Richard
[EMAIL PROTECTED]
http://people.zeelandnet.nl/pa3gcu/
-
To unsubscribe from this list: send the line "unsubscribe linux-newbie" in
the body of a message to [EMAIL PROTECTED]
Please read the FAQ at http://www.linux-learn.org/faqs
