YOu should not use lilo to boot Windows NT coz of the way that NT uses the
MBR. Instead what you must do is to consult your howto and go to the part
about windows nt linux and lilo, then use your erd to get NT booting again.
What you can also try is to find a program named bootpart (dos program) this
program will do the linux part of the deal for you. All you just need to do
is to use your erd to get your nt booting again.
Cheers
Langa (newbie)
> -----Original Message-----
> From: [EMAIL PROTECTED]
> [mailto:[EMAIL PROTECTED]]On Behalf Of Debasis Tripathy
> Sent: Thursday, May 06, 1999 11:16 AM
> To: [EMAIL PROTECTED]
> Subject: Boot problem
>
>
> Hello gurus,
>
> I have a windows NT m/c with a 4.3GB hard disk.
> I made a 2Gb partition to install linux.
> The installation completed successfully and LILO was also configured.
> Now when I chose linux at the LILO prompt it loads linux and everything
> is smooth but if I chose Windows NT the OS does not boot, instead giving
> a lot of errors.... LILO is loaded in the MBR.
> What should I do?
>
> regards,
> debasis
>
> -====---====---====---====---====---====---====---====---====---==
> ==---====-
> to unsubscribe email "unsubscribe linux-admin" to
> [EMAIL PROTECTED]
> See the linux-admin FAQ: http://www.kalug.lug.net/linux-admin-FAQ/
>
