You say "assumed using PAP". What do you mean by this?
If you mean you aren't sure that it uses PAP, you should check this by
dialing to the line using (say) minicom or seyon and seeing what you see. If
you get a login: prompt after connection, that's your problem -- you need
chat to send your userid and password before it returns control to pppd.
>From the log extract you sent, it appears that pppd is sending LCP packets
and not getting an LCP response from the host. Instead, it is probably
getting an ascii response ("not 8-bit clean") from the other end, which
makes me suspect you've "assumed" the wrong authentication method.
Apologies in advance if I've guessed wrong. Hope this helps. Good luck.
At 09:09 AM 7/29/99 -0400, Weizhong wrote [in part]:
>I am trying to setup ppp connection with BellSouth ISP. It is assumed using
>PAP. Here is the error log I got:
....
>Jul 29 08:34:13 rg pppd[2345]: sent [LCP ConfReq id=0x1 <magic 0xa6984c04>
><pcomp> <accomp>]
>Jul 29 08:34:40 rg last message repeated 9 times
>Jul 29 08:34:43 rg pppd[2345]: LCP: timeout sending Config-Requests
>Jul 29 08:34:43 rg pppd[2345]: Connection terminated.
>Jul 29 08:34:43 rg pppd[2345]: Receive serial link is not 8-bit clean:
>Jul 29 08:34:43 rg pppd[2345]: Problem: all had bit 7 set to 0
------------------------------------"Never tell me the odds!"---
Ray Olszewski -- Han Solo
Palo Alto, CA 94303-3603 [EMAIL PROTECTED]
----------------------------------------------------------------
