On 9 Aug 99, at 19:02, Arandir wrote:
> Sounds like the print's going off into the ether. Try uping lp1 instead of lp0.
> On my system, I only have one parallel port, LPT1 under DOS, but under Linux it
> is lp1 and not lp0. Try "ls > /dev/lp1" to see if that the port or not.
from the vterm I get an error message:
bash: /dev/lp1: Device not configured
so I went into printtool and edited the printer to lp1 and tried
the printtool test. error message
couldn't write file "dev/lp1": no such device or address.
and back to vterm with same result as above.
