Hi Adam, On Mon, Oct 19, 2009 at 9:59 PM, Adam Nielsen <[email protected]> wrote: >> If you know the specific ports that use used with the DRAC5, you can do >> port scans with the nmap utility. For example, "nmap -p1-65535 -P0 >> 192.168.0.1" You would have to loop using this particular example but >> it is one method.... > > Thanks for the suggestion, I ended up doing something similar. I > connected a laptop directly to the DRAC (as the switch was only passing > traffic in a different subnet) and tried to telnet to the device on port > 22 as it is running an SSH server. Unfortunately it didn't answer on > the old address I had configured (or any other addresses in the subnet > thanks to a for loop) so I'm a bit confused as to what's happened to it! > Maybe the card has locked up? Didn't respond to pings either, and arp > reported no MAC address for the device's IP. The DRAC's traffic LEDs > were blinking at every ping though, showing that it was at least > receiving the ARP requests.
Did you set your IP on the laptop to be in the same subnet as the IP of the DRAC? Actually you do not need a laptop. You can add a secondary IP on a server that has the NIC in the same VLAN as the DRAC card and set the secondary IP to be in the same subnet as the DRAC one. If the DRAC answers to ARP you will see it in you MAC address table. > > Looks like I'll have to reboot the server at some point :-( > > Cheers, > Adam. > > _______________________________________________ > Linux-PowerEdge mailing list > [email protected] > https://lists.us.dell.com/mailman/listinfo/linux-poweredge > Please read the FAQ at http://lists.us.dell.com/faq > _______________________________________________ Linux-PowerEdge mailing list [email protected] https://lists.us.dell.com/mailman/listinfo/linux-poweredge Please read the FAQ at http://lists.us.dell.com/faq
