From: Niklas Söderlund <niklas.soderlund+rene...@ragnatech.se>

The EthernetAVB should not depend on the bootloader to setup correct
drive-strength values. Values for drive-strength where found by
examining the registers after the bootloader has configured the
registers and successfully used the EthernetAVB.

Signed-off-by: Niklas Söderlund <niklas.soderlund+rene...@ragnatech.se>
Reviewed-by: Geert Uytterhoeven <geert+rene...@glider.be>
Signed-off-by: Simon Horman <horms+rene...@verge.net.au>
---
 arch/arm64/boot/dts/renesas/r8a7795-salvator-x.dts | 18 ++++++++++++++++--
 1 file changed, 16 insertions(+), 2 deletions(-)

diff --git a/arch/arm64/boot/dts/renesas/r8a7795-salvator-x.dts 
b/arch/arm64/boot/dts/renesas/r8a7795-salvator-x.dts
index 5158ba3f9ce3..277ab8484e0c 100644
--- a/arch/arm64/boot/dts/renesas/r8a7795-salvator-x.dts
+++ b/arch/arm64/boot/dts/renesas/r8a7795-salvator-x.dts
@@ -247,8 +247,22 @@
        };
 
        avb_pins: avb {
-               groups = "avb_mdc";
-               function = "avb";
+               mux {
+                       groups = "avb_link", "avb_phy_int", "avb_mdc",
+                                "avb_mii";
+                       function = "avb";
+               };
+
+               pins_mdc {
+                       groups = "avb_mdc";
+                       drive-strength = <24>;
+               };
+
+               pins_mii_tx {
+                       pins = "PIN_AVB_TX_CTL", "PIN_AVB_TXC", "PIN_AVB_TD0",
+                              "PIN_AVB_TD1", "PIN_AVB_TD2", "PIN_AVB_TD3";
+                       drive-strength = <12>;
+               };
        };
 
        du_pins: du {
-- 
2.7.0.rc3.207.g0ac5344

Reply via email to