Hallo teman-teman, ini ada temanku yg komputernya lagi kena trouble.
Apakah ada yang bisa bantu....
----- Forwarded -----
My computer that I use is:
Pentium Celeron 300A
I Will BD100
Memory I Will PC-100 32 Mb
Two weeks ago, I overclock my computer using the jumper (releasing the
jumper in RS0). Yesterday I flash the BIOS using the new update which I
obtain from I Will homepage. I follow the procedur and success (i've reboot
the computer, and it run smoothly). An hour after that, I find out that I
can increase the CPU bus from BIOS setup, then I try using 106 MHx (If I'm
not wrong). It did it. Then I give n another try to 112 MHz, after I reboot
the computer the screen gone blank (black). It happens all the time (even I
heard the memory counting).
I think this is because of the setting, so I decide to clear the CMOS by
changing the jumper cap of JP1 from 1-2 close to 2-3 close than set to 1-2
again (because there are no specific time in the manual to short the 2-3, so
I try it 20 seconds). But I didin't work. Then I try do the same again but I
short it about 2 hours. It didn't work as well. Then I release the CMOS
battery (for half hour) then put it back again. It also didn't work as well.
What should I do? The screen is still blank until now.....
Please HELP ME !!!
--------------------------------------------------------------------------
Utk berhenti langganan, kirim email ke [EMAIL PROTECTED]
Informasi arsip di http://www.linux.or.id/milis.php3
Pengelola dapat dihubungi lewat [EMAIL PROTECTED]
Hosted by http://www.Indoglobal.com
