> An hour after that, I find out that I can increase the CPU bus from BIOS
> setup, then I try using 106 MHx (If I'm not wrong). It did it. Then I give n
> another try to 112 MHz,
Never succesfull 300A overclocked at over 100 mhz reported! You able to
overclock 300A by using 100 /83/75/66 Mhz clockspeed and changing the multiplier
(like my experiences with 300, I run LINUX in overclocked CPU 300 - 366
(overclocked)) but you are not allowed to overclock 300A with clockspeed over
than 100 mhz ( maybe it just run well in PII 333 above or C400 above),
otherwise, theCPU burned..!
>
> I think this is because of the setting, so I decide to clear the CMOS by
> changing the jumper cap of JP1 from 1-2 close to 2-3 close than set to 1-2
> again (because there are no specific time in the manual to short the 2-3, so
> I try it 20 seconds).
> To clear the CMOS setting you should On your PC then put off the Jumper 8 (
> for clear CMOS or refer to you manual and seek for the CMOS jumper) , after it
> cleared, put on the jumper again as previously.Sett the CMOS correctly.
other way, you Turn off the PC, then Turn on with press the "end" or "shift"
button to use new CMOS setting, untill the CMOS appears (or refer to your MB
Manual), for further information contact me via email NOT in this MILIST. see
u..:-)
--------------------------------------------------------------------------
Utk berhenti langganan, kirim email ke [EMAIL PROTECTED]
Informasi arsip di http://www.linux.or.id/milis.php3
Pengelola dapat dihubungi lewat [EMAIL PROTECTED]
Hosted by http://www.Indoglobal.com
