Hi Samyeer! > I tried with that one but I got stuck a little earlier. I got to the point of > being able to insert and remove devices but as soon as I got interrupts working > it used to crash. It was then that I tried the 0.8 driver and that worked with > some basic modifications to the address and irq setup.
I just tried out the driver you sent me (Hugo's one) and I also get an oops when I try to remove the driver. Also when I plug in a device I get the following: ------------< snip <------< snip <------< snip <------------ usb_control/bulk_msg: timeout usb-ohci.c: unlink URB timeout usb.c: USB device not accepting new address=3 (error=-110) hub.c: USB new device connect on bus1/1, assigned device number 4 usb_control/bulk_msg: timeout usb-ohci.c: unlink URB timeout usb.c: USB device not accepting new address=4 (error=-110) hub.c: USB new device connect on bus1/1, assigned device number 5 usb_control/bulk_msg: timeout usb-ohci.c: unlink URB timeout usb.c: USB device not accepting new address=5 (error=-110) ------------< snip <------< snip <------< snip <------------ -- Regards Abraham "His eyes were cold. As cold as the bitter winter snow that was falling outside. Yes, cold and therefore difficult to chew..." __________________________________________________________ Abraham vd Merwe - 2d3D, Inc. Device Driver Development, Outsourcing, Embedded Systems Cell: +27 82 565 4451 Snailmail: Tel: +27 21 761 7549 Block C, Aintree Park Fax: +27 21 761 7648 Doncaster Road Email: [EMAIL PROTECTED] Kenilworth, 7700 Http: http://www.2d3d.com South Africa
msg07110/pgp00000.pgp
Description: PGP signature
