Markus Raab wrote:
I have a 4 port usb card with the chip: VIA VT6202 Ver. 8.0.
With 2.6.6 just one Port works with it.
When i connect a usb device to the working port
following error appears:
That's wierd. You're not the only one reporting such problems
with a VT6202 lately -- overcurrent, then failures.
- Dave
hub 4-0:1.0: USB hub found
hub 4-0:1.0: 4 ports detected
hub 4-0:1.0: over-current change on port 3
hub 4-0:1.0: over-current change on port 4
ehci_hcd 0000:00:0c.2: port 4 reset error -110
hub 4-0:1.0: hub_port_status failed (err = -32)
ehci_hcd 0000:00:0c.2: port 4 reset error -110
hub 4-0:1.0: hub_port_status failed (err = -32)
ehci_hcd 0000:00:0c.2: port 4 reset error -110
hub 4-0:1.0: hub_port_status failed (err = -32)
ehci_hcd 0000:00:0c.2: port 4 reset error -110
hub 4-0:1.0: hub_port_status failed (err = -32)
ehci_hcd 0000:00:0c.2: port 4 reset error -110
hub 4-0:1.0: hub_port_status failed (err = -32)
hub 4-0:1.0: Cannot enable port 4. Maybe the USB cable is bad?
usb 3-2: new full speed USB device using address 2
usb 3-2: USB disconnect, address 2
Markus
-------------------------------------------------------
This SF.Net email is sponsored by: GNOME Foundation
Hackers Unite! GUADEC: The world's #1 Open Source Desktop Event.
GNOME Users and Developers European Conference, 28-30th June in Norway
http://2004/guadec.org
_______________________________________________
[EMAIL PROTECTED]
To unsubscribe, use the last form field at:
https://lists.sourceforge.net/lists/listinfo/linux-usb-devel
