forwarded on Nick's request Simon ---------- Forwarded Message ----------
Subject: Re: ADSL modem and IPCOP Date: Sat, 20 Apr 2002 13:55:30 +1200 From: Simon Hansman <[EMAIL PROTECTED]> To: Shaun <[EMAIL PROTECTED]> Hi, Yeah I had a similar problem...I got it working in the end, although my hard drive on the ipcop machine has just died :(. Anyway there were a couple of things I changed to make it work. First you need to make sure your green and red interfaces are on different subnets. I think the default ip address for the router is usually 192.168.0.1, so you could make your internal network 192.168.1.x. Secondly, I fiddled around the the dhcp settings on my router (an asus one), and set the time for one session down to an hour, I don't know why this was an issue but it seemed to work after this. Finally, when configuring ipcop (login as setup), the red interface (the one connected to the modem) should be using DHCP and you'll need to give it a name (eg, ipcop). Anyway hope that helps, later Simon On Sat, 20 Apr 2002 13:42, Shaun wrote: > I have had an IPCOP box active as a firewall for my dial up connection > for a few weeks now but have just purchased a Dynalink RTA 020 and > subscribed to Jetstart and cannot figure out how to configure IPCOP > and the RTA 020 to allow me to use them together. The RTA 020 works > fine with its default settings when connected directly to the hub but > when trying to go out via the IPCOP machine I cannot seem to get it to > work. > > Any light thrown on this would be appreciated. > _______________________________________________________ -- Simon Hansman <[EMAIL PROTECTED]> <[EMAIL PROTECTED]> ------------------------------------------------------- -- Simon Hansman <[EMAIL PROTECTED]> <[EMAIL PROTECTED]>
