Hello All,
I know this is a windoze question, but the expertise of this group is why I use
Linux in the first place.
I will be setting up cable internet access in the next day or so. The ISP only
recognizes windoze. (The SxS site shows me how to get around that w/
Linux). It requires that you change your workgroup to @home, as well as the
computer name. However, I have dual nic cards of two different types. My
home net is setup using the old BNC type coaxial cables and I just put in an
RJ45 10/100 card for use with the cable modem. No challenges and SuSE 7.2
sees them both and has no issues.
My question, as I got no help from the windoze literature, is how do I set up
more than one workgroup under windoze ME? Then I want to route from the
BNC card to the RJ45 card, which will be my gateway. It will have a dynamic
IP address from the ISP provider, Comcast@home.
I know there are @home users on the lists. Have any of you done this with 2
NIC cards? It will be tough to change all the cards to RJ45 at this point.
Overview of current setup:
HOMENET - workgroup
mixed Linux/windoze boxes
Dual boot box has windoze ME with
BNC NIC ethernet card on 192.168.1.x homenet
RJ45 NIC ethernet card on as yet to determine IP address
have set it to 192.168.1.x for the time being
All other boxes only have one NIC card all set in the 192.168.1.x
range and are using BNC type connectors
I know, I need to get with the times, but this house is rented and BNC was able
to be setup using existing holes the owner drilled for his speaker wires...go figure.
Any and all help/thoughts/suggestions would be appreciated.
Regards,
Keith B.
_______________________________________________
http://linux.nf -- [EMAIL PROTECTED]
Archives, Subscribe, Unsubscribe, Digest, Etc
->http://linux.nf/mailman/listinfo/linux-users
