> For STA mode configure legacy basic rates according to info
> mac80211 provides to us, as well as follback registers, which
> are setup in vendor driver under CONFIG_STA_SUPPORT .
> For LB_FBK_CFG1 register use values from vendor driver, which
> are different for mt76x0 and mt76x2 .
>
> Signed-off-by: Stanislaw Gruszka <[email protected]>
> ---
> drivers/net/wireless/mediatek/mt76/mt76x02_util.c | 12 ++++++++++++
> 1 file changed, 12 insertions(+)
>
> diff --git a/drivers/net/wireless/mediatek/mt76/mt76x02_util.c
> b/drivers/net/wireless/mediatek/mt76/mt76x02_util.c
> index 87ce6a51fb05..2be4b527477f 100644
> --- a/drivers/net/wireless/mediatek/mt76/mt76x02_util.c
> +++ b/drivers/net/wireless/mediatek/mt76/mt76x02_util.c
> @@ -678,6 +678,18 @@ void mt76x02_bss_info_changed(struct ieee80211_hw *hw,
> tasklet_enable(&dev->pre_tbtt_tasklet);
> }
>
> + if (changed & BSS_CHANGED_BASIC_RATES &&
> + vif->type == NL80211_IFTYPE_STATION) {
> + mt76_wr(dev, MT_LEGACY_BASIC_RATE, info->basic_rates);
> + mt76_wr(dev, MT_VHT_HT_FBK_CFG0, 0x65432100);
> + mt76_wr(dev, MT_VHT_HT_FBK_CFG1, 0xedcba980);
> + mt76_wr(dev, MT_LG_FBK_CFG0, 0xedcba988);
> + if (is_mt76x2(dev))
> + mt76_wr(dev, MT_LG_FBK_CFG1, 0x87872100);
> + else
> + mt76_wr(dev, MT_LG_FBK_CFG1, 0x00872100);
> + }
> +
since these values are constant, why not put them init_vals?
Regards,
Lorenzo
> if (changed & BSS_CHANGED_BEACON_INT) {
> mt76_rmw_field(dev, MT_BEACON_TIME_CFG,
> MT_BEACON_TIME_CFG_INTVAL,
> --
> 1.9.3
>
