>> 5. ./buildtarget bitworks/ims >> 6. cd bitworks/ims/ims >> 7. make > > IMS uses a NSC pc87351 for the super IO. > > Make sure you change the SuperIO to match your board. Or you won't > get any output. > > Remember that if it "works" all you are going to get is a dump of the > SPD, some messages on copying and jumping to RAM and then it will > crash. Everthing else is on the ToDo list. :) > >> 9. sudo ../../../util/flashrom/flashrom -w linuxbios.rom >> >> Calibrating delay loop... ok >> No LinuxBIOS table found. >> No EEPROM/flash device found.
I'm guessing the write enable did not happen. you can'd ID flash without write cycles working. ron -- linuxbios mailing list [email protected] http://www.openbios.org/mailman/listinfo/linuxbios
