Here's my serial config..., also these dont show up if i just run "make ads8272_defconfig". I have to explicitly go and enable the serial options.
# # Serial drivers # CONFIG_SERIAL_8250=y CONFIG_SERIAL_8250_CONSOLE=y CONFIG_SERIAL_8250_NR_UARTS=4 # CONFIG_SERIAL_8250_EXTENDED is not set # # Non-8250 serial port support # CONFIG_SERIAL_CORE=y CONFIG_SERIAL_CORE_CONSOLE=y # CONFIG_SERIAL_CPM is not set # CONFIG_SERIAL_JSM is not set CONFIG_UNIX98_PTYS=y CONFIG_LEGACY_PTYS=y CONFIG_LEGACY_PTY_COUNT=256 Thanks! ashutosh On 7/14/05, Allen Curtis <acurtis at onz.com> wrote: > > => setenv bootargs console=ttyCPM0,115200 root=/dev/ram > > => bootm fe600000 > > ## Booting image at fe600000 ... > > Image Name: 2.6.12 for 8272 > > Image Type: PowerPC Linux Kernel Image (gzip compressed) > > Data Size: 875845 Bytes = 855.3 kB > > Load Address: 00000000 > > Entry Point: 00000000 > > Verifying Checksum ... OK > > Uncompressing Kernel Image ... OK > > > > Can you provide your kernel configuration information regarding the > serial ports. Which serial port is your console port? Check the > following configuration options: > CONFIG_SERIAL_CONSOLE > CONFIG_SCC_CONSOLE > CONFIG_SERIAL_CORE > CONFIG_SERIAL_CORE_CONSOLE > > Another observation is that you are trying to boot with a RAM disk but > you have not provided the RAM disk address to the bootm command. This > is not your current problem since you don't get that far. > > - Allen > >
