Hi all! There is a problem with 2.6.25.4 kernel on the pq2fads based board. The board resets after "MMU:exit" called (early debuging is used).See the attached log:
======== ## Booting kernel from Legacy Image at 00200000 ... Image Name: Linux-2.6.25.4 Image Type: PowerPC Linux Kernel Image (gzip compressed) Data Size: 1534783 Bytes = 1.5 MB Load Address: 00000000 Entry Point: 00000000 Verifying Checksum ... OK Uncompressing Kernel Image ... OK ## Flattened Device Tree blob at 00800000 Booting using the fdt blob at 0x800000 Loading Device Tree to 007fe000, end 007fffff ... OK Xid mach(): done MMU:enter MMU:hw init MMU:mapin MMU:setio MMU:exit <<---- the reset was here :( U-Boot 1.3.3-dirty (Jun 2 2008 - 15:43:45) MPC8260 Reset Status: Check Stop, External Soft, External Hard MPC8260 Clock Configuration - Bus-to-Core Mult 4x, VCO Div 2, 60x Bus Freq 25-75 , Core Freq 100-300 - dfbrg 1, corecnf 0x1a, busdf 4, cpmdf 1, plldf 1, pllmf 4, pcidf 3 - vco_out 330000000, scc_clk 82500000, brg_clk 20625000 - cpu_clk 264000000, cpm_clk 165000000, bus_clk 66000000 CPU: MPC8260 (HiP4 Rev 14, Mask C.0 5K25A) at 264 MHz ======== Can anyone help me with this? Thanks. _______________________________________________ Linuxppc-embedded mailing list Linuxppc-embedded@ozlabs.org https://ozlabs.org/mailman/listinfo/linuxppc-embedded
