Hey Everyone, So I can do the failover and yes all of the switches are managed. I did see where to setup the LAGG on the pfSense system. I have to deconfigure the two nics I want to use and then set them up in failover mode I think. On the switch side, I was using 2 separate switches with rapid spanning tree on their uplink ports and ports to the pfSense system to assist in fast failover. I will give it a shot on Monday and see how it goes.
Thanks. Joe -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Chris Buechler Sent: Sunday, September 11, 2011 1:04 AM To: pfSense support and discussion Subject: Re: [pfSense] NIC Failover On Sun, Sep 11, 2011 at 12:46 AM, Austin G. Smith <[email protected]> wrote: > I have had issues with stp on the firewall in this type setup previously. > Mileage may vary for others.. > If you're bridging, yeah that can be a concern depending on your config. Failover lagg without bridging won't cause any issues with STP though. May see switches on occasion that have an issue with a MAC quickly moving from one port to another related to its CAM table, or sometimes with security features on the switch, but that's pretty unusual with typical switch configs. And usually in that scenario you're going to be on two diff switches anyway with failover lagg. _______________________________________________ List mailing list [email protected] http://lists.pfsense.org/mailman/listinfo/list _______________________________________________ List mailing list [email protected] http://lists.pfsense.org/mailman/listinfo/list
