Thanks Greg and Chris.
Turns out my Belkin modem doesn't support half bridge, and a new Draytek Vigor 
120 modem that supports PPPoE to PPPoA bridging is on it's way.
Cheers,
Craig


On 4 Nov 2011, at 10:30 AM, Greg Hennessy wrote:

>> There's another layer of NAT as the modem does NAT- here in NZ it's PPoA so 
>> pfSense can't connect if the modem is in bridge mode.
>> Consequently, pfSense wouldn't even see it's WAN IP change....
> 
> Time to change/reconfigure the router. It should be configured in PPP half 
> bridge mode, which will handle the point to point encapsulation and 
> authentication, but pass the WAN assigned address through the DSL router to 
> the device making the DHCP request on the inside interface. 
> 
> This has worked just fine for yours truly over PPPoA in the UK with 3 
> different types of router, I've found Thomson Speedtouch support for Half 
> Bridge mode to be impeccable. 
> 
> http://wlug.org.nz/Half%20bridge%20with%20PPPoA
> 
> 
> 
> 
> Regards
> 
> Greg  
> _______________________________________________
> List mailing list
> [email protected]
> http://lists.pfsense.org/mailman/listinfo/list

_______________________________________________
List mailing list
[email protected]
http://lists.pfsense.org/mailman/listinfo/list

Reply via email to