> There's another layer of NAT as the modem does NAT- here in NZ it's PPoA so 
> pfSense can't connect if the modem is in bridge mode.
> Consequently, pfSense wouldn't even see it's WAN IP change....

Time to change/reconfigure the router. It should be configured in PPP half 
bridge mode, which will handle the point to point encapsulation and 
authentication, but pass the WAN assigned address through the DSL router to the 
device making the DHCP request on the inside interface. 

This has worked just fine for yours truly over PPPoA in the UK with 3 different 
types of router, I've found Thomson Speedtouch support for Half Bridge mode to 
be impeccable. 

http://wlug.org.nz/Half%20bridge%20with%20PPPoA




Regards

Greg  
_______________________________________________
List mailing list
[email protected]
http://lists.pfsense.org/mailman/listinfo/list

Reply via email to