Hi Chris,

udp     58.28.20.150:5060 <- 192.168.11.15:5060         MULTIPLE:MULTIPLE       
udp     192.168.11.15:5060 -> 10.1.1.2:53918 -> 58.28.20.150:5060       
MULTIPLE:MULTIPLE       

Hans' response that they had a problem when the dynamic IP was changed seemed 
plausible
I just disconnected the modem and reconnected to get a new IP and that killed 
the phone 
There's another layer of NAT as the modem does NAT- here in NZ it's PPoA so 
pfSense can't connect if the modem is in bridge mode.
Consequently, pfSense wouldn't even see it's WAN IP change....

Is there a way to force a state reset periodically, or is that part of the 
mythical
http://redmine.pfsense.org/issues/855

;-)

Cheers,
Craig
ps- and thanks everyone on this list for helping- much appreciated.


On 3 Nov 2011, at 12:28 PM, Chris Buechler wrote:

> On Wed, Nov 2, 2011 at 4:30 AM, Craig Drown <[email protected]> wrote:
>> Hi,
>> sorry to be dense, but not sure how to tell you what the states look like.
>> Last time it happened filtering States on the LAN ip of the SIP box returned 
>> no entries.
>> If I do the same thing when it's functioning: a page-ful of entries- do you 
>> want specifics?
> 
> Just go to Diagnostics>States, put the phone's internal IP in the
> filter, and paste everything that shows (which should just be one
> firewall state and one NAT state for SIP, unless the phone is doing
> something unusual. Maybe RTP states if a call is active or has been
> recently).
> _______________________________________________
> List mailing list
> [email protected]
> http://lists.pfsense.org/mailman/listinfo/list

_______________________________________________
List mailing list
[email protected]
http://lists.pfsense.org/mailman/listinfo/list

Reply via email to