...or the WAN interface and 'out'?  Is that not the same as LAN interface
and 'in'?  And if you are selecting all interfaces, then surely the
direction would have no effect?  Because it would either match on the LAN
side, or the WAN side...  Or am I just not getting what 'out' rules are for?

Kind regards, 

Seb


  _____  

From: [email protected] [mailto:[email protected]]
On Behalf Of Fuchs, Martin martin.fuchs-at-trendchiller.com |pfSense/Allow +
Forward to Syntec|
Sent: 15 December 2011 13:30
To: [email protected]; pfSense support and discussion
Subject: Re: [pfSense] 'direction' of firewall rules for floating rules?



Hi !

Yes, the direction has some relevance for the floating rules, because when
the direction  is wrong, the packets will not pass the firewall.

When you want to allow a packet to pass the firewall from the LAN side to
the WAN side you have to select the LAN interface and as direction you have
to select "in" (from the view of the firewall)

 

Regards,

 

martin

 

Von: [email protected] [mailto:[email protected]]
Im Auftrag von Seb
Gesendet: Donnerstag, 15. Dezember 2011 14:06
An: 'pfSense support and discussion'
Betreff: [pfSense] 'direction' of firewall rules for floating rules?

 

Hi list,

 

Does the 'direction' of a firewall rule have any relevance for floating
rules?  I can't find any explanation for what direction means in the docs,
even when it applies to individual interfaces (where I can see what it might
mean), but for floating rules that apply to all interfaces - I don't suppose
it changes much?  Perhaps just affects connections from the firewall itself
if you have it set to out but not in?

 

pfSense 2.0

Kind regards, 

Seb

_______________________________________________
List mailing list
[email protected]
http://lists.pfsense.org/mailman/listinfo/list

Reply via email to