Hi,
  in using pfsense 1.2 like edge router/firewall in a small voip operator,
it's working well from several years, I can give you some 'real life'
benchmark.

Server is:
HP DL with a 3075 XEON
hw.model: Intel(R) Xeon(R) CPU            3075  @ 2.66GHz

Ethernet card is
HP NCT-360T
dev.em.0.%desc: Intel(R) PRO/1000 Network Connection Version - 6.2.9
dev.em.1.%desc: Intel(R) PRO/1000 Network Connection Version - 6.2.9

I have some vlan with inter-vlan routing/firewalling, total WAN traffic is
around 40mbit (all RTP) small packets... I have 100mbit on the VLAN trunk
interface...

In this scenario and with this hardware pfsense works well, but if I try to
increase traffic I start to see a jitter , the CPU IRQ  load start to
become greater than 60%... I studied a little bit about polling, with linux
the e1000 drivers have a system to mitigate interrupt load ( i didn't yet
tested if linux has better performance than freebsd) I googled and i found
some test about pfsense and linux (vyatta) but the test was done with
realtek cards, and it's depends too much to the quality of the drivers....


In my opinion the 'polling' is not too bad... with a 1000hz kernel means
1ms of additional delay and delay it's better than jitter in rtp.

Do you think i can continue to use pfsense or will it be better to use an
L3 switch like cisco 3750G ?
_______________________________________________
List mailing list
[email protected]
http://lists.pfsense.org/mailman/listinfo/list

Reply via email to