What kind of throughput do you get if you hook up the pfsense to the WAN, but only hook your PC to the LAN side instead of the entire internal LAN?
Larry Hiscock AngelicHost.net > Not close at all, i have a hard limit at 50,000, The GUI is telling me > the machine can handle 197,000. I average about 5-7k, with a peak of > about 15k. > > I have a hard time believing it's pfsense because of the fact it works > perfectly fine on another internet circuit. Config, Same amount of > traffic, users, ect is all the same. > > Adam > > On 9/12/2013 12:15 PM, Christian Borchert wrote: >> How close are you to running out of states? >> Sent via BlackBerry from T-Mobile >> >> -----Original Message----- >> From: Adam Piasecki <[email protected]> >> Sender: [email protected]: Thu, 12 Sep 2013 11:28:47 >> To: pfSense support and discussion<[email protected]> >> Reply-To: pfSense support and discussion <[email protected]> >> Subject: [pfSense] pfSense and Cable Modem Throughput >> >> First I'm almost certain this is a cable modem/provider problem. We have >> a 20mb ethernet circuit that works fine with the same pfSense. >> >> We upgraded to a 100/10mb cable modem, when we put this on the WAN of >> the pfsense, we are getting major packet loss during peak times, and >> speed test sites that won't even load. Non-peak times we get no packet >> loss, good speed tests (50+mb) >> >> The problem I'm having is that when we take the pfSense out and plug a >> PC directly into the cable modem, the speedtests look fine and the >> dropped packets go away. Both during peak times and non-peak. >> >> My thought is the number of packets going over the cable modem with the >> pfSense is a lot greater then just one PC doing a speedtest, and the >> cable modem can't handle it. We have about 100 clients behind the >> pfSense trying to access the internet during peak times. The traffic >> graphs on pfSense only indicate we are doing 5-10mbs download and 1-5 >> upload, so we are no where near maxing out the cable modem bandwidth >> wise. >> >> I've checked wan ethernet settings 1gig full duplex, no collisions or >> errors on the pfSense side. I don't see any problems in the log, we are >> not doing any traffic shaping. >> >> The cable modem provider says if you plug a PC into the modem and you >> get a good speed test, then it's your firewall. I tend to agree with >> him, but the firewall works fine with the 20mb Ethernet circuit, and it >> also works fine during non-peak times when not many users are on. >> >> Has anyone run into a problem like this before, or have any tips to >> prove what could be the problem. >> >> Thanks, >> Adam >> >> _______________________________________________ >> List mailing list >> [email protected] >> http://lists.pfsense.org/mailman/listinfo/list >> _______________________________________________ >> List mailing list >> [email protected] >> http://lists.pfsense.org/mailman/listinfo/list > > > _______________________________________________ > List mailing list > [email protected] > http://lists.pfsense.org/mailman/listinfo/list > > _______________________________________________ List mailing list [email protected] http://lists.pfsense.org/mailman/listinfo/list
