Hi Jigish! Am 25.02.2017 08:30, schrieb Jigish Gohil: > > See parts under "If you are not using Tumbleweed..." here > https://en.opensuse.org/SDB:KIWI-LTSP_quick_start
I set up a Suse Leap 42.2 in a VM. Then tried to copy the instruction from the page above into the console, changing 42.1 to 42.2. However, zypper refuses it because the URL contains a ":" Did I get something completely wrong here? > > Install kiwi-image-ltsp64 and kiwi-image-ltsp-boot64 packages from > tumbleweed repo, edit LTSP_PROFILES="i386 x86_64" in > /etc/sysconfig/kiwi-ltsp LTSP_PROFILES="i386 x86_64" Do you know why the LTSP stuff was put in the Tumbleweed repos and not in the Leap ones too? > > You might have to update kiwi-desc-ltsp and kiwi-ltsp packages from > tumbleweed repo if the following does not work, not sure if PROFILES > were implemented before your server installation. What do you mean PROFILES? One more question: There is a link to another, very old page about network. It says there should be two NICs on the server. I could of course install my VM like this, do you think this is better to make the stuff run? And what about network anyway, now everything is running out-of-the-box, i. e. the Suse VM uses the DHCP from our router to be assigned an IP etc. Would it be better to have fixed addresses and its own DHCP server (like the old server has) before I proceed with installing LTSP? Regards Rolf ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, SlashDot.org! http://sdm.link/slashdot _____________________________________________________________________ Ltsp-discuss mailing list. To un-subscribe, or change prefs, goto: https://lists.sourceforge.net/lists/listinfo/ltsp-discuss For additional LTSP help, try #ltsp channel on irc.freenode.net
