Hi, I would let your internal nicad charge up for a while. Was the internal battery every replaced? This behavior is typical of a nicad that is at low voltage. cheers Steve
On Thu, Sep 17, 2015 at 4:13 AM, Arthur F. Tyde III <[email protected]> wrote: > Hi All, pulled out my m200 from storage. Batteries in, all good - runs > basic programs. Screen isn't too bad. However, I press the power > button and immediately get two horizontal lines on the LCD display. No > way to recover - even removing the batteries - reset doesn't work. If I > turn off the mem switch, and turn back on it'll come back up but > everything is gone. Has anyone seen anything like this? Cheers, Arthur... > >
