hope to be able to be able to jump on a future round
On Fri, Feb 23, 2018 at 5:32 PM, Joe Grubbs <[email protected]> wrote: > Thanks Jim, this is very helpful > > > ------------------------------ > *From:* M100 <[email protected]> on behalf of Jim > Anderson <[email protected]> > *Sent:* Friday, February 23, 2018 2:38 PM > *To:* [email protected] > *Subject:* Re: [M100] 4 REXes available > > > -----Original Message----- > > > > I know this batch were pre-programmed for the 100 (and 102), but I > > assume it's easy enough to make it 200 compatible? > > It's pretty straightforward in that it doesn't require any specialized > chip-programming hardware. As long as you have a TPDD or TPDD emulator > already working with your machine, it's just a matter of putting a couple > of files in the TPDD (or emulator) and running a few commands on the T200. > > http://bitchin100.com/wiki/index.php?title=REX_Release_4.9 > > After putting the REX in your T200 ROM socket, scroll down to the section > 'Rebuilding REX' and follow steps 2, 4, and 5 (steps 1 and 3 are only > needed if you already had the REX working in your machine, although > obviously the part of step 1 about backing up your RAM files is important, > since in step 5 you'll be doing a cold restart). Use the files for release > 162, though, not 236. They're linked a little bit further down the page. > > This is a good process to be familiar with anyways, as this is essentially > how you'd go about upgrading your REX to a future software release. > > > > > > > > jim >
