Thanks Kurt. I notice in the manual.do file, there's a line: "mComm 1.51 now has a full TPDD service". There are several other references to 1.51, but the window header reads "mComm v. 2.50". Maybe that manual is a bit long of tooth? Several of the installation instructions, and usage instructions, can't be followed, result in errors, or give no response.
Tom M. On Thu, Apr 18, 2019 at 9:56 AM Kurt McCullum <[email protected]> wrote: > Tom, > > I'll have to check the manual when I get home. The older versions of mComm > supported a straight TELCOM mode for those without TS-DOS or TEENY. That > was a menu based system that could transfer files straight to TEXT or BASIC > with a few steps. But once I added the ability to inject DOS into the > laptop, I scrapped that feature for the virtual modem. I suspect I didn't > update the old manual file when I did that. Sounds to me like you have it > working properly. With the UR-2 you will be able to load not only TS-DOS > but also Sardine. > > Kurt > > On Thu, Apr 18, 2019, at 5:54 AM, Thomas Morehouse wrote: > > Good morning all. > > I've downloaded (from Club100) and run the mComm Setup250.exe file on my > Win10 laptop. > > Installation ran smoothly. Crank it up from the desktop shortcut, and > mComm 2.5 opens. > > I click "Start Service", and can send a file from my 102 to the DATA > folder, using the UR2 TS-DOS function. > > But I read in the manual (in the DATA folder) that there's a menu in mComm. > > Where is the menu? > > Thanks. > Tom M. > M102 with UR2 > > >
