I just checked the online manual. It's definitely outdated as well. I'll have to update both of them.
For now, I can say this. 2.5 has full support for TPDD protocols as well as sector access to an emulated Sardine Dictionary disk. If you go into TELCOM and hit enter, you will be in virtual modem mode. That allows TELNET and SSH connections. ATDT URL:Port will connect to a telnet sight ATDS URL:Port will create a SSH connection Other that that, the TELCOM mode has been removed in favor of injecting TS-DOS. Kurt On Thu, Apr 18, 2019, at 7:20 AM, Kurt McCullum wrote: > Tom, > > Yes, the manual needs to be updated. Lots of changes have been made since > 1.51. There is a newer manual that I posted in my members file area that is > web based. Even that is a little out dated though. > > Apparently that's my next project. Update all the manuals. > > Kurt > > On Thu, Apr 18, 2019, at 7:04 AM, Thomas Morehouse wrote: >> Thanks Kurt. I notice in the manual.do file, there's a line: "mComm 1.51 now >> has a full TPDD service". There are several other references to 1.51, but >> the window header reads "mComm v. 2.50". Maybe that manual is a bit long of >> tooth? Several of the installation instructions, and usage instructions, >> can't be followed, result in errors, or give no response. >> >> Tom M. >> >> >> On Thu, Apr 18, 2019 at 9:56 AM Kurt McCullum <[email protected]> wrote: >>> __ >>> Tom, >>> >>> I'll have to check the manual when I get home. The older versions of mComm >>> supported a straight TELCOM mode for those without TS-DOS or TEENY. That >>> was a menu based system that could transfer files straight to TEXT or BASIC >>> with a few steps. But once I added the ability to inject DOS into the >>> laptop, I scrapped that feature for the virtual modem. I suspect I didn't >>> update the old manual file when I did that. Sounds to me like you have it >>> working properly. With the UR-2 you will be able to load not only TS-DOS >>> but also Sardine. >>> >>> Kurt >>> >>> On Thu, Apr 18, 2019, at 5:54 AM, Thomas Morehouse wrote: >>>> Good morning all. >>>> >>>> I've downloaded (from Club100) and run the mComm Setup250.exe file on my >>>> Win10 laptop. >>>> >>>> Installation ran smoothly. Crank it up from the desktop shortcut, and >>>> mComm 2.5 opens. >>>> >>>> I click "Start Service", and can send a file from my 102 to the DATA >>>> folder, using the UR2 TS-DOS function. >>>> >>>> But I read in the manual (in the DATA folder) that there's a menu in mComm. >>>> >>>> Where is the menu? >>>> >>>> Thanks. >>>> Tom M. >>>> M102 with UR2 >>>> >>> >
