Mike, You don't need the TS-DOS ROM (but it's sure nice to have). mComm can send the RAM version over to your unit. It's slow and takes about three and a half minutes but it works. Teeny can be pushed over too and is much faster.
Kurt On Sat, Aug 31, 2019, at 12:18 PM, Mike Warns wrote: > Thank you, Kurt and Josh. I connected the two at 6:00 AM and now I need to > find/remember the Teeny instructions. I had a M102 with the TSDOS ROM, but it > got stolen. I didn't stay up til 6am, I just slept with the whole rig then > waited until it got bright enough to read the screen. > > I'll try my WP2 with an Android tablet (only one of mine works with an OTG > cable) when my daughter gets out of the hospital. She'll find either the WP2 > or my better M100 and give up. Either is good. > > Kurt, I have some suggestions for the mComm docs but I need to verify them > before I pass them along. > > >> On Sat, Aug 31, 2019 at 12:56 PM, Josh Malone >> <[email protected]> wrote: >> >> On Sat, Aug 31, 2019, 8:06 AM Kurt McCullum <[email protected]> wrote: >>> __ >>> Drivers are built into mComm. FTDI, Prolific, ch240 are supported. But the >> >> >> Ah - thanks for the correction.
